which cisco ios switch command is used to configure the use of lacp on an interface?

They are not commonly invoked, because they take effect only during rare events such as a supplicant that stops functioning mid-authentication or a transmission failure on the wire. Note: Supp-timeout and max-req are similar to tx-period and max-reauth-req except that they apply only after the supplicant has responded to the initial Request-Identity message. See the Router Interface Summary Table at the end of the lab to determine which interface identifiers to use based on the equipment in the lab.

Other routers, switches, and Cisco IOS versions can be used.

During the subsequent authentication process, the retransmission of EAP Request frames are handled by max-req, not max-reauth-req. The switch commands and output are from Cisco WS-C2960-24TT-L switches with Cisco IOS Release 15.0(2)SE4 (C2960-LANBASEK9-M image). Note: The Request-Identity frames are sent only in the session initiation phase. The best practice configuration for the 802.1X timeout period that works for most environments is about 30 seconds. Timeout = (max-reauth-req +1) * tx-period The total time it takes for 802.1X to time out is determined by the following formula: Endpoints without a supplicant must wait until 802.1X times out before getting network access via a fallback mechanism. The combination of tx-period and max-reauth-req is especially important to non-IEEE-802.1X-capable endpoints. The number of times it resends the Request-Identity frames is defined by dot1x max-reauth-req variable.

It waits for a period of time defined by the dot1x timeout tx-period timer and then sends another Request-Identity frame. Which Cisco IOS command is used to display the automatic sequence numbers that have been assigned to the statements of a numbered IP ACL Which Cisco IOS command would configure an extended IP ACL statement that denies all HTTP traffic from the 10.10.20.128/25 network to the 172.17.1. At link-up, the switch sends an EAP Request-Identity frame.

Which cisco ios switch command is used to configure the use of lacp on an interface?